Skip to main content

Day 9

May 17, 2017

I got back on the boat for the last time. I'm only down here for two days 😟

Today was all hands on deck and we were hand sanding the places that the orbital sanders could get at. After finishing sanding the deck we got to priming it. When I started priming, I noticed I was blinking a lot and my eyes were watering, so I decided it was probably best to wear some eye protection. We put two coats of primer on today, and we should be able to paint tomorrow!


Comments

Popular posts from this blog

Weekly Reflection 3

    This week was a short one comparative to the previous one. I only ended up working two days, but I was very productive in both of them. It made me sad to leave the Roseway, I'm not sure when I might see it again. I think my time on the boat was very valuable.     Something I struggled with this week, and throughout my time has been balancing between being quick with my work versus being meticulous. On one hand, the boat needs to get repaired quickly so it can begin its summer programs, but at the same time, it can't be done sloppily so the work goes to waste.     I struggled to find this balance when painting and priming. At first, I was extremely careful and meticulous, making sure to paint with as near perfection as I could. Once I got into the groove though, I found myself going too fast and making careless mistakes like dripping paint in places that it shouldn't have gone. By the end of it, I think I found a good balance between speed...

Day 7

May 11, 2017 Today was yet another busy day at yard aboard the Roseway. I started off the day by helping “horse” cotton to fill seams that I had pulled up yesterday. To “horse” is essentially just a fancy way of saying whacking the heck out of it with a huge hammer (called a beetle) to push it into the seams. After the seams were horsed, I helped put the calking back in the seams (the calking is the same rubber seams I mentioned I pulled up in earlier blogs). This was a very messy process, and if I got any of the calking on my shoes, then I had to take them off or clean them so I didn’t track it all over the deck. It was somewhat unavoidable though, and I ended up with both of my shoes off at one point. After finishing up calking, I continued away at my ongoing mission to sand everything forward of the break in the deck. I quickly finished up the waterways and bulwarks as I had finished most of them in the previous days. Today I really started getting after the king plank, wh...